Axle spacer to fit R1 4C8 rear wheel into legend rear swing arm

Description:Aide

This is basically so I can figure out what size bushes to be made to fit R1 4c8 rear wheel into triumph legend swing arm. This will enable wheel to be kept central horizontally while I measure top hat spacers needed to centralise wheel in frame.
Material = seamless steel tube
Length = 268 mm
OD = 27.95 mm
ID =20 mm

I stipulate seamless because is close tolerance on legend axle which on average measures 19.95mm along length.
The .05 mm in difference is the same between bearings on R1 ID =28 mm and axle is 27.95.
This allows for snug interface between spacer- legend axle and R1 bearings
All measurements are in mm

----------------------------------
Ajouté le 20/07/2020 16:44

This spacer can be made in two halfs if that makes it easier

----------------------------------
Ajouté le 23/07/2020 20:03

Ok to do it in seam welded as long as seem doesn`t intrude into ID and it fits over 19.95 axle and if it`s easier it can be done in two lengths of 134 mm